Provides the convenience of a built-in photocell that automatically turns the transformer on at dusk.  Programmable 4, 6, or 8-hour intervals can be set to turn lights off saving electricity and prolonging bulb life.

• Features
  
  • Photocell timer automatically turns power on and off at dusk
  • Set desired on time in 4, 6 and 8 hour intervals
  
  WARNING
  
  This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire with an appropriate grounding plug.
  
  1) Do not repair, or tamper with, this cord or plug.
  2) Do not use extension cords.
  3) Do not submerge transformer.
  4) Do not connect two or more power supplies in parallel.
  5) Do not use with a dimmer.
  
  Fixture(s) must be installed in accordance with all local codes and ordinances! For use with low voltage outdoor landscape lighting systems and LGPC submersible fixtures. Not for use with pool/spa equipment.
  
  Disclaimer
  
  This lighting system is designed to last for many years under normal conditions. However, lamps eventually burn out and losing one can shorten the life of the others. Conditions beyond control (high input voltage, poor voltage regulation, etc.) will also affect lamp life. It is, therefore, important to replace a burned out lamp promptly.
  
  Instructions
  
  1) To connect low voltage cable, split one end of cable approximately 2” and strip about 1/2” of insulation off each wire (diagram 1). Insert wire under terminal as shown (diagram 2). Tighten screw securely.
  2) Hang transformer from a secure object such as a post or the side of your home (diagram 3).
  3) Plug transformer into a GFCI outdoor electrical outlet that has a weather-resistant cover, do not use extension cord.
  4) Route low voltage cable to desired fixture locations. Hook up fixtures to LVL cable.
  
  CAUTION: Fixture(s) must be installed in accordance with all local codes and ordinances. Turn power pack to “AUTO” and cover photocell for 30-60 seconds to test. Hide or bury cable as desired only aft er entire installation is completed and lighting effect is achieved.
  
  Setting Timer
  
  A) AUTO - turns unit on at dusk/off at dawn
  B) 4H - turns unit on at dusk/off after 4 hours
  C) 6H - turns unit on at dusk/off after 6 hours
  D) 8H - turns unit on at dusk/off after 8 hours
  
  Troubleshooting
  
  1) Make sure transformer is plugged in. Is outlet working?
  2) Caution: If circuit breaker trips when the transformer is turned on – Unplug the transformer from the AC outlet. Correct fault. Reset the circuit breaker and plug transformer back in.
  3) Is lamp burned out? Use another lamp to test.
  4) To maximize the life of the transformer and lights. The transformer should only be operated at 80% of its total wattage (ie. 80% of 60 watts = 48 watts).