Package Includes:

• Plumbing AquaBasin™ 4 way FPT Splitter (1)
• Fitting Elbow ¾” MPT x ¾” Barb (2)
• Plumbing ¾” Barbed Ball Valve (2)
• Fitting Barbed 90 Degree Elbow ¾” (2)
• Fitting 9/16” to 1 ¼” Hose Clamp (9)
• Pipe Kink Free ¾” x 6’ Cut (2)
• Fitting Barbed Male Hose Adap ¾” x ¾” (1)

Installation

1) Attach 4 way FPT splitter to threaded adapter on pump. (Threaded adapter included in AquaBasin™ Pump Kit 1500).
2) Screw the one ¾” MPT x ¾” Barb elbow on the left and right end of the splitter. Screw the ¾” x ¾” barbed male hose adapter on the top end of the splitter.
3) Cut a 2” section of tubing and place over end of each barbed adapter and secure with hose clamp.
4) Place ball valve over each section of tubing and secure with hose clamp.
5) Taking each section of 6’ tubing from kit, one section will be included from AquaBasin™ pump kit 1500, and put on opposite end of ball valve and secure with hose clamps.
6) Run tubing to each decorative piece, cut tubing at base of decorative piece and place 90 degree elbow on each end of tubing securing with hose clamp.
7) Take left over section of each tubing and place on opposite end of 90 degree elbow and secure with hose clamp. Run tubing to and through the end of decorative piece and cut off any excess tubing.

Troubleshooting

Water is coming out the bottom but not out the top?

Make sure tubing is as close to the top of decorative piece as possible. If water still continues to run down center hole, try using silicone or foam (not included) and place around tubing inside the center hole. This will prevent the water from running down the center.

Too much/little water is coming out?

Adjustment of ball valve may be necessary. Adjust ball valve to desired water flow.